WTW7500GC0 Error Code List

WTW7500GC0 Error Codes

Whirlpool Washer Error Code List

LF |

This Whirlpool Washer error code list applies to model WTW7500GC0 and all the models listed under the related models section below.

Whirlpool Washer WTW7500GC0
Questions For Model WTW7500GC0

F6e3 Error Code

When I power up, all LED stay On and display shows :55 number. If I push any buttons it beeps but nothing changes at all. When I go to diagnostic mode it shows F6E3 code If I reset power by unpug and plug power cord it makes no difference at all, same problem remains. What is wrong with this washer, how to fix this problem? Please help, I cannot afford to buy a new washer due to my disability and low income. Thanks

The F6E3 error code is a communication error between the main control board the user interface control board. It may just be a loose connection between the boards. Unplug the connections between the boards and plug them back in and see if that helps if not then most likely the main control board has failed. In most cases it's the main control board but it could be the user interface board. What I advise if the wiring checks out ok between the boards is to replace both boards as you can get both board used in good condition for a fairly reasonable price. If you want the part numbers for the boards just post a new question and include your model number and ask for the part numbers for the main control and user interface boards. Thanks.

Cycle Runs But No Water

Hello, My washer has a water button inside that will allow me to prewash clothes. Now that function works. However when I choose a program and go to run it. It doesn’t fill the water up while going through the cycle leaving the clothes still dry. The soap and softener are still in the holder and hasn’t been released. So I know it didn’t wash clothes. Should I try resetting it before other drastic measures.

The only thing you can do is try and reset the electronics by killing power to it at the breaker/fuse panel on your home for one full minute then restore power. If after that the problem persists the water level pressure switch will need to be replaced. The water level sensor on that model is built into the main control board so the part number you would need is W11040850.

Ask A Question
Ask a question about model WTW7500GC0

Have a question about this model?
Fill out the form and a certified appliance technician will answer your question usually within 24 hours. You will be notified by email once your question is answered. Questions not related to this model will not be answered. Find the error you need help with in our database. If it's not in our database submit it on our code info request page.

Related Whirlpool Washer Models
This WTW7500GC0 error code list also applies to the following models
WTW7500GC0
WTW7500GC2
WTW7500GW0
WTW7500GW2