Can’t get the door open and the water splashed out earlier. How do I fix this. Where do I order the part?
The Whirlpool Duet Washer F32 Error is a water level pressure switch failure code. If there is no voltage to the pressure switch from the central control unit or if the contacts in the pressure switch are worn out the central control will report this error and shut the cycle down.
This error is most commonly caused by a failed water level pressure switch. However it can be a wiring issue between the switch and central control unit so be sure to check the wiring for loose connections or damaged wires. It can also be a bad pressure switch circuit on the central control unit but this is not as common. If the wiring looks ok replace the pressure switch and if it the error persists after that replace the central control unit. The part information and replacement instructions for both parts can be found at the pages linked below.
Click Here For Part Information And Replacement Instructions For The Water Level Pressure Switch
Click Here For Part Information And Replacement Instructions For The Central Control Unit
This Whirlpool Duet Washer F32 error troubleshooting and repair information applies to model WFW9200SQ00 and all the models listed under the related models section below.
Can’t get the door open and the water splashed out earlier. How do I fix this. Where do I order the part?
Please post your question to our partner site's repair forum and include the model number of your washer. Also give more specific details. When you say water splashed out, where did water splash out from? Is the washer tub full of water if so the control is not going to allow the door to unlock. You can post your question at the link below:
Have a question about this error code?
Fill out the form and a certified
appliance technician will answer your question usually within 24 hours. You will be notified by email once your question is answered. Questions not
related to this error will not be answered. Find the error you need help with in our database. If it's not in our database submit it on our code info request page.